Pioneer Super Tuner III D DVH-P5850MP - Manual (Page 65)

Black plate (65,1)
<CRB2123-A/U>65
2 Press m or n to switch the down
mix settings.
! Lt/Rt  Down mix so that the surround
components can be restored (decoded).
! Lo/Ro  Stereo mix the original audio that
do not contain channel modes such as sur-
round components.
Using the Dolby Pro Logic II
Only when the multi-channel processor (e.g.,
DEQ-P7650) is connected to this unit, you can
operate this function.
Dolby Pro Logic II creates five full-bandwidth
output channels from two-channel sources to
achieve high-purity matrix surround.
! If both the center and the rear speakers are
set to OFF, you cannot use this function.
! Dolby Pro Logic II supports up to 48kHz
sampling rate stereo source and has no ef-
fect on other types of source.
1 Press and hold EQ-EX until PLII appears
in the display.
2 Press EQ-EX to select the desired mode.
! MOV (movie)  The Movie mode suitable
for movie playback
! MUS (music)  The Music mode suitable
for music playback
! MAT (matrix)  The Matrix mode for when
FM radio reception is weak
! PLII :OFF Turn Dolby Pro Logic II off
# You can adjust the music mode only when
MUS (music) has been selected.
# To cancel Dolby Pro Logic II, press EQ-EX
again to select PLII :OFF.
Adjusting the Music mode
You can adjust the Music mode with the fol-
lowing three controls.
! Panorama (PANO) extends the front stereo
image to include the surround speakers for
an exciting wraparound effect.
! Dimension (DIME) allows you to gradually
adjust the sound field either towards the
front or the rear.
! Center Width Control (CENT) allows center-
channel sounds to be positioned between
the center speaker and the left/right speak-
ers. It improves the left-center-right stage
presentation for both the driver and the
front passenger.
1 Press EQ-EX until MUS (music) appears
in the display.
2 Press n to select PANO.
Press r or q to turn PANO on/off.
3 Press n again to select DIME.
Each time you press r or q it moves the
sound towards the front or the surrounds.
+3  3 is displayed as the front/surround
speaker balance moves from front to sur-
rounds.
4 Press n again to select CENT.
Each time you press r or q it gradually
spreads the center channel sound into the
front left and right speakers over a range 07.
3 is the default and its recommended for
most recordings. 0 places all center sound in
the center speaker. 7 places all center sound
equally in the left/right speakers.
Digital Signal Processor
En
65
Section
12
Digital
Signal
Proce
ssor