Pioneer Super Tuner III D DVH-P5850MP - Manual (Page 68)

Black plate (68,1)
<CRB2123-A/U>68
Adjusting the speaker output
levels using a test tone
A convenient test tone allows you to easily get
the overall balance right among the speakers.
1 Press A and hold until FRONT appears
in the display, then press A to select
T TONE.
After FRONT is displayed, press A until
T TONE appears in the display.
2 Press n to start the test tone output.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
FRT-L (front speaker left)CENT (center
speaker)FRT-R (front speaker right)RER-R
(rear speaker right)RER-L (rear speaker left)
SUB.W (subwoofer)
# Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the test
tone.
# The settings do not appear for speakers
whose size is set OFF.
3 Press r or q to adjust the speaker
output level.
Each press of r or q increases or de-
creases the speaker output level. +10  10 is
displayed as the level is increased or de-
creased.
# The test tone rotates to the next speaker after
about two seconds from the last operation.
4 Press m to stop the test tone output.
5 Press BAND to return to the playback
display.
Notes
! If needed, select speakers and adjust their ab-
solute output levels. (Refer to Adjusting the
speaker output levels on the previous page.)
! To adjust the speaker output levels in this
mode is the same as making the speaker out-
put levels at FRT-L. Both provide the same re-
sults.
Using the time alignment
Only when the multi-channel processor (e.g.,
DEQ-P7650) is connected to this unit, you can
operate this function.
The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
1 Press A and hold until FRONT appears
in the display, then press A to select
INITIAL.
After FRONT is displayed, press A until
INITIAL appears in the display.
# You cannot select INITIAL when neither F/L
nor F/R is selected in POSI.
2 Press m or n to select the time
alignment.
! INITIAL  Initial time alignment (factory set-
ting)
! CUSTOM  Adjusted time alignment that
you can create for yourself
! AUTO TA  Time alignment created by auto
TA and EQ. (Refer to Auto TA and EQ (auto-
time alignment and auto-equalizing) on the
next page.)
! TA :OFF  Turn the time alignment off
# To turn time alignment off, select TA :OFF.
# You cannot select AUTO TA if auto TA and EQ
has not been carried out.
3 Press BAND to cancel the time align-
ment mode.
Digital Signal Processor
En
68
Section
12