Pioneer KURO PRO-141FD - Manual (Page 55)

55
En
Use Other Equipment With Your Flat Panel Display 06
6.3.2 Specify the HDMI Input Type
To select a signal type, follow the steps below.
1 ) Select the Input for the connected equipment.
Press the INPUT button (remote control or panel) until the correct input is showing (INPUT 5, INPUT 6,
INPUT 7, or INPUT 8).
2 ) Access Input Setup 2/2 through the Input Setup menu.
3 ) Select INPUT 5(HDMI 1), INPUT 6(HDMI 2), INPUT 7(HDMI 3) or INPUT 8(HDMI 4).
4 ) Select Signal Type from the submenu.
5 ) Select the appropriate option.
6 ) Press EXIT to exit the menu.
In Video mode, the image is over-scanned (enlarged) but the panel automatically switches to PC when receiving
computer signals. In PC mode, the image displays in full size for optimum image quality.
6.3.3 Specify a Digital HDMI Signal Type
For the correct digital video signal type, check the operating manual that came with the other equipment.
To assign the type of digital signal,follow the steps below.
1 ) Access Input Setup 2/2 through the Input Setup menu.
2 ) Select INPUT 5(HDMI 1), INPUT 6(HDMI 2), INPUT 7(HDMI 3) or INPUT 8(HDMI 4).
3 ) Select Video from the submenu.
4 ) Select the type of digital video signal recommended for the attached device.
5 ) Press EXIT to close the menu.
If an image fails to appear, specify another digital video signal type. Type parameters other than Auto need to be
checked for natural colorings.
Option Description
Video use except when a PC is connected (default)
PC when a PC is connected to HDMI input terminal
Type Description
Auto automatically identifies input digital signals
1 (YUV422) Digital Component Video signals (4:2:2) locked
2 (YUV444) Digital Component Video signals (4:4:4) locked
3 (RGB16-235) Digital RGB signals (16 to 235) locked
4 (RGB0-255) Digital RGB signals (0 to 255) locked
Video (over-scan) PC (under-scan)
PRO-141FD_PRO-101FD.book Page 55 Monday, May 12, 2008 3:27 PM