Phonetics 1104 - Manual (Page 63)

Chapter 5: Alarm Programming
51
6. The Model 1104 audibly recites the configuration for each
of the four inputs:
• If the input is normally open, the Model 1104 recites the
number of the input and says“OK.”
• If the input is normally closed, the Model 1104 recites
the number of the input, followed by a “beep”
and“OK.”
• If the input is configured as temperature, the
Model 1104 recites the number of the input, followed by
“Temperature.”
5.1.2 Verifying Input Configuration
Input configuration can be verified when interrogating the
Model 1104 for a complete Status Report. Refer to Chapter 6
for a more detailed description of the Status Report.
5.2 Enable/Disable Inputs
This function allows you to enable or disable an input’s
response to an alert condition. An enabled input will respond to
an alert condition and allow dial-out. A disabled input will
cause dial-out to be suppressed, but any existing alert condi-
tions will be revealed during the Status Report. Enable/disable
programming is useful during wiring of inputs (see Chapter 2)
or when a condition needs to be monitored, but is not critical
enough to be programmed for dial-out reporting. It is important
to verify input status after performing any task that requires
disabling. The default setting for all inputs is enabled (ON).
If an alert condition exists when inputs are re-enabled,
Recognition Time will restart—refer to Section 5.3.