Phonetics 1104 - Manual (Page 85)

73
Chapter 6: Acknowledgment, Status Report, and Remote Access
6.2.2 Example: Status Report, Existing Alarms
Inputs 2, 3,and 4 are configured as dry contact and input 1 is
configured as temperature. An emergency situation is at hand:
a fire in a greenhouse has tripped a smoke alarm and electrical
power has been disrupted. In addition to high sound and AC
power alarms, separate alarms exist on inputs 1, 2, 3, and 4.
You happen to call in for the Status Report, which begins with,
“Hello, this is telephone number 555-1234; the time is
12:15 PM.” Following this introduction, the report continues:
“Number 1, 110 degrees, HIGH.”
“Number 2, EXISTS.”
“Number 3, EXISTS.”
“Number 4, EXISTS.”
“The electricity is OFF.”
“Battery condition, OK.”
“Sound level, HIGH.”
“Warning message received by ...(last telephone number
dialed*).”
“Listen to the sound level for 10 seconds.”
The Status Report repeats once more and the Model 1104
concludes the call by saying: “Have a good day.”
* The “last telephone number dialed” refers to any one of the
programmed, dial-out telephone numbers through which the
Model 1104 was able to receive alarm acknowledgment, prior
to your call for a Status Report; this could also refer to the
Model 1104’s I.D. Number (identification number), if the
alarms are acknowledged at the keypad by someone present at
the site.