Panasonic BB-HCM403A - Manual (Page 109)

Operating Instructions
109
Note
• Due to the network environment, object, the number of simultaneous
access, enabling IPsec or SD memory recording, the camera may not
record number of images that you set. In this case, set the image buffer
frequency longer.
• Set Every [1 s], buffer [1] images for the SD memory recording.
7. Select the transfer method, and click [Next>].
• Clicking [<Back] takes you back to the previous page.
• Clicking [Cancel] takes you back to the Trigger page without saving
changes.
Note
• If you transfer images by E-mail or FTP, confirm that the default gateway
and DNS server addresses are assigned correctly (see page 41 or page
45).
Setting Description
Enable Pre-trigger
Image Buffer • Check the box to enable the setting. The camera
buffers or transfers the image right before the motion
detection signal is detected.
• Set an interval, number of images to buffer and total
number. The number of buffered images may not
match the total number (see page 177) due to memory
capacity, image resolution, image quality or what object
you view.
Enable Post-trigger
Image Buffer • Check the box to enable the setting. The camera
buffers or transfers the image right after the motion
detection signal is detected.
• Set an interval, number of images to buffer and total
number. The number of buffered images may not
match the total number (see page 177) due to memory
capacity, image resolution, image quality or what object
you view.