Panasonic DMR-E20 - Manual (Page 30)

30
TV
TV/AV
PROG / CHECK
TOP WINDOW
TV/TEXT
STOP
SV/V+
REC
TIME SLIP
AV LINK
SETUP
AUDIO
REC MODE CANCEL
INPUT
SELECT
MANUAL
SKIP
LAST
MARKER
DIRECT
TV REC
TIMER
REC
1 2 3
4 5 6
7 8 9
0
PAUSE PLAY
STATUS
RETURN
VOL
OPEN/CLOSE
T C E R I D
R O T A G I V A N
TO
P
M EN
U M E N
U
DISPLAY
T SI L Y A L P
ENTER
TV DVD
TV ASPECT
FRAME
SKIP SLOW/SEARCH
Á
2
3 4
1 /
5
5
Timer recording
Using ShowView code* (G-code) to make timer recording
* ShowView code : for Continental Europe.
G-code : for Australia, N.Z. and Asia.
G-
CODE and S HOW V IEW are different trademarks used to represent the same easy recording
feature. However, for simplicity, only the term G- CODE will be used. If you use S HOW V IEW
system, follow the same steps listed for the G- CODE system.
[RAM] [DVD-R]
Remote control only
You can easily programme the unit to make a timer recording of a programme by entering the
programme’s ShowView code (G-code), which can be found in the television sections of
newspapers or in television guides. You can programme up to 16 programmes one month in
advance. Programmes for everyday or every week are counted as one programme.
Preparation
≥Switch [DVD, TV] to “DVD”.
≥Ensure that this units clock is set correctly.
≥Insert a disc for recording (make sure there is enough room for the programme you are going to
record plus a little extra).
1 Press [SV/V+] ([G-CODE]).
<ShowView> <G-code>
2 Press the numeric buttons to enter the code.
≥If you enter the wrong digit, use the joystick [2] to move back and enter the correct digit.
3 Press [ENTER].
≥The Timer Programme Correction screen which allows you to confirm the programme
appears and make corrections if necessary.
≥Check the programme.
To make corrections (page 31).
To programme other recordings, repeat steps 1, 2, and 3.
4 If the programme is correct
Press [ENTER].
≥The Timer Programme List screen appears.
5 Press [PROG/CHECK] or [RETURN].