Printek Mt2 Series - Manual (Page 10)

Getting Started
Installing The Battery
The battery compartment is conveniently located on the bottom of the printer. To install the battery, perform
the following steps.
• Unlock the battery door by sliding the Battery Door Release toward the center of the door.
• Open the battery door.
• Orient the battery so that the two contacts on the battery will be face down, and will correspond with the
two contacts inside the printer’s battery compartment, and set the battery into the compartment. A label
showing this orientation is also located inside the battery compartment.
• Close the battery door.
• Lock the battery door closed by sliding the Battery Door Release toward the edge of the battery door.
Bottom of the Printer Showing Battery Compartment
Charging the Battery Before Use
Note: One battery is included with the printer. The battery must be fully charged before using the printer.
• Charge the battery by plugging the AC adapter into a wall outlet and inserting the other connector into the
printer.
• The Amber BATTERY CHARGING indicator will illuminate indicating that the battery is being
charged.
4