Printek Mt2 Series - Manual (Page 17)

Printer Configuration
The printer’s configuration is controlled using switches which are located in the battery compartment as shown
below.
Configuration Switch Location
Some of these switches control the communications interfaces which include Serial RS232 and IrDA on the
Mt2 models, and the additional Bluetooth interface on the Mt2B models. These interface switches must be set
to match the settings on the host computer system in order for the host and printer to communicate properly.
In the case of Mt2B models, the printer’s Auto Power Off feature is also controlled by one of these switches.
These switch assignments are shown in the following table. Following the table are detailed descriptions of
how to use these switches to control each interface and the printer’s power.
For information regarding optional serial cables, or for information regarding software drivers and printing
utilities for various host operating systems, please refer to “Printer Supplies and Accessories” on page 27.
Switch Position(s) Function
SW1 Communication Interface
Off RS232/Bluetooth Enabled
On IrDA Enabled
SW2 SW3 Baud Rate
Off Off 38,400
Off On 19,200
On Off 9,600
On On 2,400
SW4 Manual Power Control (Mt2B)
Off Manual Control Disabled
On Manual Control Enabled
SW5 Reserved
SW6 SW7 Parity bit
Off Off No Parity
On Off Odd Parity
On On Even Parity
SW8 Reserved
11