Printek Mt2 Series - Manual (Page 12)

Getting Started
Loading the Paper Roll
Attaching The Belt Loop System
The belt loop system consists of two parts:
• A knob located on the back part of the printer just above the battery door
• A belt loop strap with a click on connector
After sliding your belt through the strap of the belt loop:
• Insert the knob located on the bottom of the printer into the slot of the belt loop connector.
• Pull down on the printer until you hear a click. The printer is now secure and can safely hang down
beside your hip.
• To release the printer, press in on the two latches on the sides of the connector and pull the printer and
knob up and clear of the slot.
Note: Do not force or pull the printer from the connector without pressing in on the two latches.
6