Panasonic WV-CS564 - Manual (Page 27)

28
■ Cleaning (CLEANING)
Built-in electric mechanical contacts are refreshed at regular
intervals (approx. 7 days) if CLEANING is set to ON.
A dry contract affects adversely picture quality and motors oper-
ation.
1. Move the cursor to CLEANING and select ON or OFF by moving
the joystick to the right or left.
The factory default setting is OFF.
ON: The contacts are cleaned as programmed for about 1
minute. “CLEANING” disappears when it is over.
OFF: No contact cleaning.
Note: Select OFF when the camera downloads or uploads the
preset data.
■ Camera Setting
To Display the Camera Setting Menu
• Move the cursor to CAMERA , and press the CAM (SET) key.
The camera setting menu appears.
● Camera Identification (CAMERA ID)
1. Move the cursor to CAMERA ID, and select ON (to display the
camera identification) or OFF by using the joystick.
The factory default setting is OFF.
2. Follow the steps below to edit the camera ID characters:
2-1 Move the cursor to CAMERA ID and press the CAM (SET)
key to display the character editing menu.
2-2 Move the cursor to the character you want to edit or change
by using the joystick, and press the CAM (SET) key. The
selected character appears in the editing area.
2-3 Repeat the steps above until all characters are edited.
** SET UP MENU **
PRESET 1
MAP
HOME POSITION
SELF RETURN
AUTO MODE
AUTO PAN KEY
LOCAL/REMOTE
PATROL
CLEANING
CAMERA
RS485 SET UP
OFF
OFF
OFF
AUTO PAN
LOCAL
STOP
OFF
Special 1 menu
CLEANING
CLEANING
** SET UP MENU **
PRESET 1
MAP
HOME POSITION
SELF RETURN
AUTO MODE
AUTO PAN KEY
LOCAL/REMOTE
PATROL
CLEANING
CAMERA
RS485 SET UP
OFF
OFF
OFF
AUTO PAN
LOCAL
STOP
OFF
Setup menu
** SET UP **
CAMERA ID
ALC/MANUAL
SHUTTER
AGC
SYNC
WHITE BAL
AF MODE
EL-ZOOM
IMAGE HOLD
RET SPECIAL
OFF
ALC
OFF
ON(MID)
INT
ATW
MANUAL S
ON
OFF