Panasonic WV-CS564 - Manual (Page 45)

47
5. Tighten the fixing screw M3 (provided).
Notes:
(1) Tighten the camera fixing screw with a
screwdriver.
(2) Follow the instructions given here to
ensure that the camera and camera
mounting base are installed safely.
(3) When removing the camera from the
camera mounting base, loosen and
press up the camera fixing screw (M3)
by using a screwdriver.
6. Fix the decoration cover to the camera
mounting base.
a. Sideway Cable Exit
Pass the cables through the cutout made in
the diecast case and decoration cover.
b. Top Cable Exit
Push the decoration cover against the cam-
era mounting base.
15
°
Be sure to match the wire with the fall
prevention wire fixing angle as shown below.
Fall prevention
wire fixing angle
Ring of the
fall prevention
wire
Cautions:
• Use the supplied dust protection sheet if the
camera mounting base is liable to be
exposed to a dusty atmosphere. Remove the
cover from the dust protection sheet, then
stick the sheet on the camera mounting
base.
• Remove the sheet before mounting the cam-
era on the base.
• While the camera is separated from the
base, keep the camera in the supplied poly-
ethylene sack.
4. Mount the camera on the camera mounting
base and rotate the camera clockwise.
3. Hook the fall prevention wire on the camera
mounting base.