Connecting up 02 – Pioneer RCS-LX60D User Manual
Page 11
Connecting up
02
11
En
1
Connect the HDD/DVD recorder to the receiver
subwoofer.
a. Plug the control cable into the
CONTROL OUT
jack
on the rear of the receiver subwoofer.
Plug the other end of the cable into the
CONTROL IN
jack on the rear of the HDD/DVD recorder.
b. Plug the coaxial cable into the
DIGITAL AUDIO
INPUT (DVD/DVR 1)
jack on the rear of the receiver
subwoofer.
Plug the other end of the cable into the
DIGITAL
AUDIO OUT (COAXIAL)
jack on the rear of the HDD/
DVD recorder.
2
Fasten the spacers to the display unit and connect.
If the display unit is difficult to view, the spacers can be
attached to allow changing of the viewing angle. Peel off
the protective paper from the spacers and press the
spacers onto the depressions on the bottom of the display
unit.
Plug the L-shaped end of the display cable into the
connector on the rear of the display unit, then plug the
other end of the display cable into
SYSTEM CONNECTOR
jack on the receiver subwoofer.
3
Assemble the AM loop antenna.
a. Bend the stand in the direction indicated by the arrow.
b. Clip the loop onto the stand.
c. If you want to fix to a wall or other surface, perform
step b after first securing the stand with screws.
It is recommended that you determine the reception
strength before securing the stand with the screws.
4
Connect the AM and FM antennas
1
.
a. Connect one wire of the AM loop antenna to each AM
antenna terminal
2
.
For each terminal, press down on the tab to open;
insert the wire, then release to secure.
b. Push the FM antenna
3
plug onto the center pin of the
FM antenna socket.
Note that unless the control cable is connected,
you
can’t use the remote control with the HDD/DVD recorder.
Note
1 • Keep antenna cables away from other cables, the display unit, receiver subwoofer and HDD/DVD recorder.
• If reception with the supplied antenna is poor, see
Improving poor FM reception
and
Improving poor AM sound
on page 29 or
Connecting
external antennas
on page 34.
• Do not attach any antenna other than the provided loop antenna, or an external antenna as described on page 34.
2 • Don’t let it come into contact with metal objects and avoid placing near computers, television sets or other electrical appliances.
• If radio reception is poor, you may be able improve it by re-inserting each antenna wire into the opposite terminal.
• For best reception, do not untwist the AM loop antenna wires or wrap them around the loop antenna.
3 To ensure optimum reception, make sure the FM antenna is fully extended and not coiled or hanging at the rear of the unit.
a
b
c
2
1
RCS-LX60D_WV.book 11 ページ ２００７年４月２４日 火曜日 午後７時５７分