Pioneer RCS-LX60D - Manual (Page 146)

The Initial Setup menu 15
146
En
Additional information about the TV system
settings
About the input line system
This recorder is compatible with PAL, SECAM, 3.58 NTSC
and PAL-60 TV systems. The Input Line System and Input
Colour System settings determine how the recorder
treats incoming video signals from an external input.
Please note the following points when changing the
input line system:
• When the current input is a built-in tuner channel
preset, changing the input line system will usually
also affect the input line system of the
AV2 (INPUT 1/DECODER) input. However if the
AV2/L1 In setting is set to Decoder , then the L2
input is affected instead.
• If, when the Input Line System setting is changed, the
screen goes blank (due to incompatibility with your
TV), you can switch back by pressing and holding the
front panel
(Stop) button then pressing
INPUT SELECT (also front panel) while the recorder is
stopped.
• When you switch the Input Line System setting the
Copy List is erased. If you switch the setting using the
(Stop) button and INPUT SELECT buttons as
described above, there is no confirmation, so please
use with care.
• You can’t mix recordings of different TV line systems
on the same disc.
• When you change this setting, the Input Colour
System setting also changes (see below).
About NTSC on PAL TV
Depending on the Input Line System setting and the
NTSC on PAL TV setting, the signal format output when
the recorder is stopped varies as shown in the table
below.
About the input colour system
The available options of the Input Colour System setting
depend on the Input Line System setting. The table below
shows the different options available.
Additional information about component
video output
If you switch the Component Video Out setting to
Progressive when using a TV that is not compatible with
progressive-scan video, you will not be able to see
anything displayed on your TV. If this happens, press and
hold the
(Stop) button on the front panel, then press
OPEN/CLOSE . This will set the recorder’s video output
back to Interlace.
Input Line System NTSC on PAL TV
Output when
stopped
625 System Off PAL
On PAL
525 System Off NTSC
On PAL–60
Input Line System
Built-in analog
tuner
External input
625 System Auto Auto
PAL PAL
SECAM SECAM
525 System n/a Auto
3.58 NTSC
PAL–60
DVRLX60D_WV_EN.book 146 ページ ２００７年４月２４日 火曜日 午後７時５８分