ProForm 831.297783 - Manual (Page 17)

17
When the cool-down period is completed, the walk-
ing belt will slow to a stop. Your fitness level will
then be shown in the
TIME/PACE display.
There are ten fitness
levelsÑfitness level 10
(FL10) is the highest.
Remember, the
FITNESS TEST is
intended only to indicate the relative fitness level
you have achieved.
Note: The SPEED and INCLINE buttons will not
function while the FITNESS TEST program is
running. If your heart rate is not detected during the
program, the letters ÒPLSÓ will flash in the CALS./
FAT CALS./PULSE display. If your heart rate is not
detected during the last thirty seconds of any 4-
minute period (after 4 minutes, after 8 minutes,
etc.), the walking belt will slow to a stop, the
FITNESS TEST will end, and the TIME/PACE
display will show a fitness level of 0 (FL00). (See
CHEST PULSE SENSOR TROUBLE-SHOOTING
on page 7.)
Note: The FITNESS TEST program cannot be
stopped for a moment and then restarted. However,
the program can be stopped at any time by press-
ing the STOP button. The TIME/PACE display will
then show an estimated fitness level.
When the program is completed, remove the key.
Step onto the foot rails. Make sure that the incline
of the treadmill is set at 1.5%. Remove the key
from the console. Store the key in a secure place. In
addition, press the on/off switch to the off position.
(See the drawing on page 11.)
6