Panduit PTR3E - Manual (Page 3)

This manual will guide you step by step in the set-up, operation, and
troubleshooting of the PTR3E Printer. If you have problems not covered
call Technical Support at 1-888-506-5400, ext. 7470.
SAFETY PRACTICES
The following general safety practices supplement the specific warnings
and cautions elsewhere in this manual. They are recommended
precautions that must be understood and applied during the operation
and maintenance of the equipment covered herein.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the product in the presence of flammable gases or fumes.
Operation of any electrical equipment in such an environment
constitutes a definite safety hazard.
DO NOT OPERATE IN WET OR DAMP AREAS
Do not operate the product in wet or damp areas. Operation of any
electrical equipment in such an environment constitutes a definite safety
hazard.
DO NOT SUBSTITUTE PARTS OR MODIFY EQUIPMENT
Because of the danger of introducing additional hazards, do not install
substitute parts or perform an unauthorized modification to the
equipment. The proper components for service and repair may be
obtained from Panduit Corp., Labeling Systems Department,
1-888-506-5400, ext. 7470. The product may also be returned for service
and repair by calling the above number and requesting a Tracking
Number. Please provide your company name, contact name, address,
telephone number and serial number of the printer (and P.O. Number if
out of warranty) when requesting the Tracking Number. After Tracking
Number is received the printer should be returned to :
Panduit Corp.
1819 Atlanta Highway
Cumming, GA 30040-1069
Attention: Labeling Systems Repair Department
WARNING
When the printer has been in use for a long time, the print head may
become hot. DO NOT touch the print head with bare hands.