Panduit PTR3E - Manual (Page 40)

This selection specifies whether or not the printer will automatically
feed a blank label when it is placed in the Online mode.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will feed a blank label anytime
it enters the Online mode. If No is selected, the display
will advance to the mode display.
This selection specifies whether or not the printer will feed a
blank label automatically when an error condition is cleared...
1.
Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will feed a blank label anytime
an error condition is cleared. If No is selected, the display
will advance to the mode display.
This selection specifies whether or not the printer will print the
last printed label stored in memory when the FEED key is
pressed in the Normal Online mode.
1.
Use the LINE key to step the cursor to desired setting. If Yes
is selected, the printer will reprint the last label when the
FEED key is pressed when the printer is Online. If the
printer is Offline, pressing the FEED key will feed a blank
label. If No is selected, the display will advance to the mode
display.
This display will only appear when the Backfeed is enabled
(DSW3-4 = OFF).The maximum backfeed distance is 255mm.
1.
Use the LINE key to select either the Default or the
Distance selection. If Default is selected, the display steps
to the Web acceleration selection.
2. If Manual setting is selected, use the LINE key to advance
the distance to the desired setting. Each time the LINE key
is pressed, the Distance will advance 1 mm. The maximum
distance is 255mm.
3. Once the desired distance is set, press the FEED key
to accept the setting and step to the next display.
This selection allows the user to specify the hexidecimal code
for the character which is replaced with the Euro Character.
The default is D5
0
.
1. The underline cursor should be positioned underneath
the first digit selection. Use the LINE key to step to the
desired setting.
2. Press the FEED key to advance the underline cursor to
the second digit of the desired hexidecimal code.
3. Press the LINE key to step to the desired setting.
4. When the setting is correct, press the FEED key to
accept the setting and step to the next display.
This selection allows the user to select the character set used by the
printer. The selections are English, French, German, Spanish
Italian and Portuguese. The default is English.
1.
Press the LINE key to advance to the desired language
setting.
2. When the setting is correct, press the FEED key to accept
the setting and step to the next display.
32
Section 3. Configuration
AUTO ONLINE FEED
YES NO
FEED ON ERROR
YES NO
REPRINT W/FEED
YES NO
FORWARD/BACKFEED
DISTANCE XXXmm
SELECT LANGUAGE
ENGLISH
FORWARD/BACKFEED
DISTANCE DEFAULT
EURO CODE
D5