Panduit PTR3E - Manual (Page 34)

PRINTER ADJUSTMENTS
The LCD Panel on the PTR3E is used in conjunction with the LINE and FEED
switches by the operator to manually enter printer configuration settings. Many of
the settings can also be controlled via software commands and in the case of conflict
between software and control panel settings, the printer will always use the last
valid setting. If you load a label job that includes software settings and then enter a
new setting via the LCD Panel, the manually set values will be used by the printer.
If you set the values manually and then download a job with software settings, the
software settings will be used.
MODE KEY SEQUENCE INITIAL DISPLAY PAGE
Normal POWER ONLINE
QTY: 000000
27
Advanced LINE + POWER ADVANCED MODE 29
Test Print FEED + POWER TEST PRINT MODE
CONFIGURATION
33
Default Setting LINE + FEED + POWER DEFAULT SETTING
YES NO
34
Clear Non-Standard Protocol DSW2-7 ON + LINE + FEED +
POWER
ALT. PROTOCOL
COMPLETE
34
Protocol Code Download DSW2-7 ON + POWER + LINE USER DOWNLOAD
PRESS THE LINE KEY
34
Hex Dump DSW2-4 ON + POWER ONLINE
QTY: 000000
35
26
Section 3. Configuration