Panduit PTR3E - Manual (Page 36)

The label Pitch distance from the leading edge (the
edge that comes out ofthe printer first) of a label and
the leading edge of the next label. The leading edge
position of the label can be adjusted relative to the
print head +/- 49 mm in increments of 1mm. Once the
position is set, it can be fine adjusted +/- 3.75mm using
the PITCH potentiometer on the Adjustment Panel.
1. The underline cursor will initially be positioned
underneath the Pitch Direction setting. Pressing
the LINE key will step the setting to the positive (+)
or negative (-) selection. A positive selection moves
the leading edge of the label forward (away from the
print head) while a negative selection moves the
leading edge of the label back the mechanism.
2. Once the correct direction is selected, pressing the
FEED key will accept the setting and advance the
cursor to the Offset selection.
3. Use the LINE key to step the first digit of the
counter to the desired setting. The display will
increment one step each time the LINE key is
pressed. The reading will advance to a setting of
4 after which it will automatically wrap and start
at 0 again.
4. Press the FEED key to accept the setting and
advance the cursor to the second digit. Again use
the LINE key to step the desired setting. Once it
is correct, pressing the FEED key will step to the
next adjustment. You may wish to print a test
label after completing the adjustments to ensure
they are correct.
28
Section 3. Configuration
± 00mm
PITCH OFFSET
Moved with negative
(-) offset to print on
trailing edge of label
ABCDEFG
ABCDEFG
ABCDEFG
Original (0 offset)first line
print position
Leading Edge of Label as
detected by the sensor
Sensor
Position
Moved with Positive
(+) Offset to print on
trailing edge of label