Nokia VT45K - Manual (Page 12)

E–10
Top Features
1. Power Button (ON / STAND BY) ( )
Use this button to turn the power on and off when the power is
supplied and the projector is in standby mode.
NOTE: To turn off the projector, press and hold this button
for minimum of two seconds.
2. Status Indicator
When this is lit red continually, it’s warning you that the
projection lamp has exceeded 1000 hours (up to 2000 hours in
Eco 2 mode and 1500 hours in Eco 1 mode) of service. After
this light appears, it is advisable to replace the projection lamp
as soon as possible. (See page E-36). In addition the message
“The lamp has reached the end of its usable life. Please re-
place the lamp.” appears each time the projector is turned on
until the lamp is replaced.
If this light blinks red rapidly, it indicates that the lamp cover
or filter cover is not attached properly or the projector is over-
heated. See the Power / Status Light Messages on page E-38
for more details.
3. Power Indicator
When this indicator is green, the projector is on; when the
indicator is orange, it is in standby mode.
4. Select ( ) / (+) (–) Buttons
: Use these buttons to select the menu of the item you
wish to adjust.
: Use these buttons to change the level of a selected
menu item.
When an image is magnified, these buttons can be used to
move the image on screen.
5. Cancel Button
Press this button to exit the menu. While you are in the adjust-
ment or setting menu, pressing this button will return to the
previous menu.
6. Enter Button
Executes your menu selection and activates items selected from
the menu.
7. Menu Button
Displays the menu.
8. Auto Adjust Button
Use this button to adjust Position-H/V and Pixel Clock/Phase
for an optimal picture. Some signals may not be displayed
correctly or take time to switch between sources.
9. Source Button
Use this button to select a video source such as a PC, VCR or
DVD player.
Each time this button is pressed, the input source will change
as follows:
→ RGB → Video → S-Video → RGB ...
If no input signal is present, the input will be skipped.
SOURCE
AUTO ADJUST
ON
STAND BY
STATUS
POWER
E
M
N
U
C N A
C
EL
T
ER
NE
SELECT
9
3
8
7 4
1
2
6 5