Nokia VT45K - Manual (Page 4)

E–2
IMPORTANT INFORMATION
Precautions
Please read this manual carefully before using your
NEC VT45 Projector and keep the manual handy for
future reference.
Your serial number is located under the name plate
label on the right side of your VT45. Record it here:
CAUTION
To turn off main power, be sure to remove
the plug from power outlet.
The power outlet socket should be in-
stalled as near to the equipment as pos-
sible, and should be easily accessible.
CAUTION
TO PREVENT SHOCK, DO NOT OPEN
THE CABINET.
NO USER-SERVICEABLE PARTS IN-
SIDE. REFER SERVICING TO QUALI-
FIED NEC SERVICE PERSONNEL.
This symbol warns the user that
uninsulated voltage within the unit may
be sufficient to cause electrical shock.
Therefore, it is dangerous to make any
kind of contact with any part inside of the
unit.
This symbol alerts the user that impor-
tant information concerning the operation
and maintenance of this unit has been
provided. The information should be read
carefully to avoid problems.
WARNING
TO PREVENT FIRE OR SHOCK, DO NOT EXPOSE
THIS UNIT TO RAIN OR MOISTURE.
DO NOT USE THIS UNIT’S GROUNDED PLUG WITH
AN EXTENSION CORD OR IN AN OUTLET UNLESS
ALL THREE PRONGS CAN BE FULLY INSERTED.
DO NOT OPEN THE CABINET. THERE ARE HIGH-
VOLTAGE COMPONENTS INSIDE. ALL SERVICING
MUST BE DONE BY QUALIFIED NEC SERVICE PER-
SONNEL.
DOC Compliance Notice
This Class B digital apparatus meets all requirements
of the Canadian Interference-Causing Equipment
Regulations.
3. GSGV Acoustic Noise Information Ordinance:
The sound pressure level is less than 70 dB (A) ac-
cording to ISO 3744 or ISO 7779.
RF Interference
WARNING
The Federal Communications Commission does
not allow any modifications or changes to the unit
EXCEPT those specified by NEC Technologies in
this manual. Failure to comply with this govern-
ment regulation could void your right to operate
this equipment.
This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential instal-
lation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communica-
tions. However, there is no guarantee that inter-
ference will not occur in a particular installation. If
this equipment does cause harmful interference
to radio or television reception, which can be de-
termined by turning the equipment off and on, the
user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
• Consult the dealer or an experienced radio / TV
technician for help.
In UK, a BS approved power cable with moulded plug
has a Black (five Amps) fuse installed for use with
this equipment. If a power cable is not supplied with
this equipment please contact your supplier.
• IBM is a registered trademark of International Business Ma-
chines Corporation.
• Macintosh and PowerBook are registered trademarks of Apple
Computer, Inc.
• Other product and company names mentioned in this user's
manual may be the trademarks of their respective holders.