Remote control features, E – 14 – NEC GT950 User Manual

Page 14

Advertising

E – 14

4. LED
Flashes when any button is pressed.

5. Power ON Button
If the main power is applied, you can use this button to turn your pro-
jector on.

6. Power OFF Button
If the main power is applied, you can use this button to turn your pro-
jector off.

NOTE: To turn off the projector, press and hold the POWER OFF button for a
minimum of two seconds.

7. VIDEO Button
Press this button to select an NTSC, PAL, SECAM or NTSC4.43 com-
patible video source from a VCR, DVD player, laser disc player or docu-
ment camera.

8. S-VIDEO Button
Press this button to select an S-Video source from a VCR.

9. RGB 1 Button
Press this button to select a video source from computer or compo-
nent equipment connected to your RGB port.

10. RGB 2 Button
Press this button to select DVI analog or DVI digital signal from a PC
with DVI output to the DVI-I INPUT connector.
The RGB 2 button toggles between DVI analog and DVI digital.

11. AUTO ADJ Button
Use this button to adjust an RGB or DVI (digital/analog) source for an
optimal picture. Some signals may not be displayed correctly or take
time to switch between sources.

12. LASER Button
Press and hold this button to activate the laser pointer. When lit, you
can use the laser to draw your audience's attention to a red dot that
you can place on any object.

13. MENU Button
Displays the menu for various settings and adjustments.

14. SELECT (

▲▼

ᮤ ᮣ

) (Mouse) Button

When you are in the Computer mode, these buttons work as a com-
puter mouse.
When you are in the Projector mode, which is indicated by lighting the
PJ button:
▲▼: Use these buttons to select the menu of the item you wish to adjust.

ᮤ ᮣ

Use these buttons to change the level of a selected menu item.
A press of the

ᮣ

button executes the selection.

When the pointer is displayed, these

▲▼

ᮤ ᮣ

buttons move the pointer.

15. ENTER (Left Click) Button
When you are in the Computer mode, this button works as the mouse
left button.
When this button is pressed and held for a minimum of 1.5 seconds,
the drag mode is set.
When you are in the Projector mode, which is indicated by lighting the
PJ button:
Use this button to enter your menu selection. It works the same way as
the "Enter" button on the cabinet.

16. CANCEL (Right Click) Button
When you are in the Computer mode, this button works as the mouse
right button.
When you are in the Projector mode, which is indicated by lighting the
PJ button:
Press this button to exit "Menus". It works the same way as the “Can-
cel” button on the cabinet.

IFT

POINTER

KEYSTONE

MAGNIFY

FREEZE

PIC-MUTE

PC CARD

FOLDER

SLIDE

LIS

OFF

VIDEO

AUTO ADJ.

S-VIDEO

RGB1

RGB2

LASER

POWER

SELECT

Remote Control Features

NOTE: If you are using a Macintosh computer, you can click either the right-
click or left-click button to activate the mouse.

NOTE: If any one of the buttons is pressed and held for 60 seconds or more,
the button operations will cease to operate. This is not a malfunction, rather it
is a feature used to prolong battery power. To cancel this feature, press any one
of the buttons other than the SELECT button.

1. Infrared Transmitter
Direct the remote control toward the remote sensor on the projector
cabinet.

2. Laser Pointer
Beams a laser light when "Laser" button is pressed.

3. Remote Jack
Connect your remote control cable here for wired operation.

OFF