NEC GT950 - Manual (Page 21)

E – 21
Wiring Diagram
Supplied serial cable
AUDIO IN
AUDIO IN
AUDIO OUT
AUDIO OUT
DVI IN
RGB IN
RGB OUT
PC CONTROL
MOUSE
OUTPUT
REMOTE
CONTROL
INPUT
AUDIO IN
AUDIO IN
R L/MONO
VIDEO
S-VIDEO
Supplied signal cable
To mini D-Sub 15-pin connector on the projector. It is
recommended that you use a commercially available distribution
amplifier if connecting a signal cable longer than the supplied one.
PC with DVI output
Macintosh
(Desktop type or notebook type)
IBM VGA or Compatible
(Desktop type or notebook type)
Supplied mouse adapter (USB)
Supplied mouse adapter
(For IBM PS/2 or USB)
DVD Player
(with component output)
Optional 15-pin-to-RCA
(female) x 3 cable
(ADP-CVI)
Monitor
Document Camera
VCR, DVD Player or
LaserDisc Player
To video, S-video, and audio
inputs on the projector.
NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning on the
power to the notebook PC. In most cases signal cannot be output from RGB output unless the notebook PC is turned on after
connecting with the projector.
NOTE: If using video, S-video, or audio cables, the cables should be 3 m (9.8 feet) or shorter.
Remote Control Guideline
1. Plug the supplied serial cable with the mouse output port of the projector into your computer’s mouse port
and restart your computer to gain remote mouse control.
2. When using the remote control’s built-in infrared mouse on a laptop computer, the laptop’s mouse, trackball
or trackpad will be disabled. Disconnect the serial cable from the mouse output port and restart your com-
puter to regain trackball or trackpad mouse control.
3. If the screen goes blank while using your remote control, it may be the result of the computer’s screen-saver
or power management software.
4. If you accidentally hit the OFF button on the remote control, wait 2 full minutes and then press the ON button
to resume.
DVI cable (not supplied)