NEC GT950 - Manual (Page 46)

E – 46
[Page6]
Communication Speed:
This feature sets the baud rate of the PC Control port (Mini DIN 8
Pin).
It supports data rates from 4800 to 38400 bps.
The default is 38400 bps. Select the appropriate baud rate for your
equipment to be connected.
Default Source Select:
You can set the projector to default to any one of its inputs each
time the projector is turned on.
Last .............. Sets the projector to default to the previous or last active
input each time the projector is turned on.
Auto ............. Searches for an active source in order of RGB → Video → S-
Video → DVI (DIGITAL) → DVI (ANALOG) → PC Card Viewer
→ RGB and displays the first found source.
Select ........... Displays the selected source input every time the projector is
started up. Select an input from the pull-down menu.
Port:
This sets the TCP port number for connection using the control
software. Please be careful not to duplicate another TCP port on
PC that runs the control software.
Gateway:
Checking this box will make the set default route valid.
When data is sent from the LAN card, the transfer location will be
searched according to the previously set routing information;
however, when the transfer location has not been found as a result
of the search, the data will be sent to the device that holds the IP
address set here.
The IP address that is set here must be one that can be identified
by a search of the routing information.
An IP address can be automatically assigned to this projector by your
DHCP server. If your network does not automatically assign IP ad-
dress, ask your network administrator for an address, and then regis-
ter it manually.
Automatic: Automatically assigns an IP address to the projector
from a DHCP server.
NOTE: The Automaic function is under development. Register it manually.
Manual: Provides a space for you to register the IP address or
subnet mask number obtained from your network administrator.
IP Address ......... Register your IP address.
Subnet Mask ...... Register your subnet mask number.
[Port, Gateway]
LAN Mode
Please consult with your network administrator about these settings.
[IP Address]