NEC GT950 - Manual (Page 22)

E – 22
AUDIO IN
AUDIO IN
AUDIO OUT
DVI IN
RGB IN
RGB OUT
PC CONTROL
R
L/MONO
VIDEO
DVI IN
AUDIO IN
RGB IN
AUDIO IN
Connecting Your PC or Macintosh Computer
Connecting your PC or Macintosh computer to your GT950 projector
will enable you to project your computer’s screen image for an impres-
sive presentation.
To connect to a PC or Macintosh, simply:
1. Turn off the power to your projector and computer.
2. Use the signal cable that’s supplied to connect your PC or Macintosh
computer to the projector.
3. Turn on the projector and the computer.
4. If the projector goes blank after a period of inactivity, it may be caused
by a screen saver installed on the computer you’ve connected to the
projector.
IBM VGA or Compatibles (Notebook type)
or
Macintosh (Notebook type)
Audio cable
(not supplied)
RGB signal cable (supplied)
To mini D-Sub 15-pin connector on the
projector. It is recommended that you use
a commercially available distribution
amplifier if connecting a signal cable
longer than the supplied one.
IBM VGA or Compatibles (Desktop type)
1 ON
DI P
2 3 4 5 6
Pin adapter for Macintosh
(not supplied)
For older Macintosh, use a commercially
available pin adapter to connect to your
Mac's video port.
The new Macintosh computer such as
G3 will have the 15 pin HD connec-
tor. The GT950's "Plug and Play" data
will be downloaded to the Macintosh.
Therefore, a Mac adapter will not be
necessary.
Macintosh (Desktop type)