NCR S10 - Manual (Page 138)

Sample Configurations
Sample RAID Configuration
C-18 NCR S10 Desktop Server User Guide
When you finish, the screen should look like the
following:
PCI IRQ Setting [Manual]
INTA INTB INTC INTD
PCI Slot 1 [ 5] [ 14] [15] [11]
PCI Slot 2 [ 14] [15] [11] [ 5]
PCI Slot 3 [15] [11] [ 5] [14]
On Board SCSI [11] [ 5] [ 14] [15]
VGA Palette Snoop [Disabled]
On Board SCSI AIC-7870 [Enabled]
Boot Device [Enabled]
4. Press [Esc] to return to the main menu in BIOS
Setup.
5. Press [Esc] again. Select Yes to save System Settings
and PCI Adapter settings and to reboot the system.
After configuring the System Settings and the PCI
Adapter settings using the BIOS Setup Utility, the
system reboots.
To configure the SCSI adapters and drivers, if connected
to an Adaptec SCSI adapter, follow these steps:
1. Press [Control] + [A] when the following displays:
Adaptec AIC-7870 BIOS v1.2
<<Press hot key for SCSI Select (TM)
Utility>>
(Refer to the Adaptec SCSI documentation for
additional information about these settings).
Configuring the SCSI
Adapters and Drives