NCR S10 - Manual (Page 140)

Sample Configurations
Sample RAID Configuration
C-20 NCR S10 Desktop Server User Guide
Extended BIOS Translation... [Enabled]
Display <CTRL-A> Message During
BIOS Initialization... [Enabled]
Multiple LUN Support [Disabled]
BIOS Support for More than 2... [Enabled]
7. Press [Enter] to return to previous menu.
8. Press [Esc] until prompted to save configuration.
Save the configuration and the system reboots.
The procedure is the same as the procedure for
configuring the memory and other baseboard settings in
the Standard Configuration. The procedure is repeated
here for your convenience.
Sometimes the EISA Configuration Utility will not boot.
If this happens, perform the following procedure:
1. Using the BIOS Setup Utility, disable all PCI
adapters.
2. Boot the EISA Configuration Utility.
3. Configure the system.
4. Go back into the BIOS Setup Utility, and re-enable
the PCI adapters.
To configure memory and other baseboard settings,
follow these steps:
1. Insert the EISA Configuration Utility in the diskette
drive. Observe that the EISA Configuration Utility
boots properly.
Configuring the
Memory and Other
Baseboard Settings