NETGEAR NMS100 - Manual (Page 28)

Reference Manual for the ProSafe Network Management System NMS100
3-8 Data and Statistics
September 2004 202-10058-01
Type-Dependent Attributes
1. Select the Attribute tab to set type-dependent
attributes. For a complete description of all type-
dependent object attributes, please see
Table 3-2
Object Properties Attribute tab.
2. To change an attribute, first select the attribute
name in the Attrib table. The selected attribute
name is displayed in the Name box and the current
value in the Value pull-down control.
3. In the Value pull-down, select one of the pull-down
values or type in a new value.
• Note that the Value pull-down does not
necessarily show all possible values for the
attribute. Use the >> button to show an
expanded selection mechanism for the selected
attribute value.
• When editing multiple objects, any attribute that has a different value for different objects
is shown as #####. Changing these attributes will set the new value for all selected
objects.
Read/Write Community The Community name used for SNMP V1/V2c operations when the
Read/Write Access Mode is used.
Trap Community The Community name expected in a received SNMP V1/V2c Trap
frame. This is used to match an incoming trap to a map object.
V3 Engineid SNMP V3 Engine Identifier (detected automatically).
V3 Context Name VSNMP V3 Context Name (normally blank).
V3 No Auth Security Name SNMP V3 Security Name to use with the noAuth access mode (no
authentication, no privacy).
V3 Auth/Priv Security Name SNMP V3 Security Name to use with authenticated or private
(encrypted) access modes.
V3 Auth Password SNMP V3 password to use for authentication.
V3 Priv Password SNMP V3 password to use for privacy (encryption).
Table 3-1. Object Properties Access tab
Attribute Name Description