NETGEAR NMS100 User Manual
Page 45
Reference Manual for the ProSafe Network Management System NMS100
Polling and Emailing
4-9
September 2004 202-10058-01
6. Then, set the Email/Page event actions
a.
Select the Actions tab of the displayed Add Event
Filter dialog.
b. Select Default from the Page Group pull-down to
send a page to all users with a Group1 or Group2
alias set to Default (the Administrator user).
c.
Select Default from the Email Group pulldown to
send email to all users with a Group1 or Group2
alias set to Default (the Administrator user).
d. Click OK to save the new filter.
7. Finally, test the new Event Filter
a.
Select the Map tab of the Selection Tool and
select one of the devices you matched in the
new event filter.
b. Use the Tools/Trap Sender menu.
c.
The TrapSend tool shows an Event Actions tree
on the left side. Open the Snmpc-Status-Polling
subtree and select the pollDeviceDown event.
d. Click the Send button.
e.
Close the TrapSend tool and look at the Event
Log Tool (at the lower part of the console). If
you do not see the Event Log Tool, use the
View/Event Log Tool menu to show it.
f.
Select the History tab in the Event Log Tool. You will see a red Device Down event for the
selected node and some white diagnostic messages about the email operation.