NEC MobilePro 880 - Manual (Page 96)

4-22 Using the NEC MobilePro
Removing CompactFlash Cards
Follow these steps to remove a CompactFlash card from the
MobilePro.
Note: Pivot the CompactFlash card button
out of the recessed space before beginning the
following procedure.
1. Save your data if you are storing it on the inserted
CompactFlash card.
2. Press the button beside the CompactFlash card.
3. When the card pops out slightly, pull it out of the slot.
Using the IR Port
With the NEC MobilePro, you can send and receive data to
and from another similarly equipped device using the infrared
(IrDA) communication port. In addition, you can use the IR
port to synchronize data with your host PC, in place of using
the PC Connect (serial) cable.
Before using the NEC MobilePro for IrDA communication,
first configure/enable the IR port on your host system, then
install Microsoft ActiveSync on your host system.
Note: If you configure/enable the IrDA port
on your host system after installing Microsoft
ActiveSync, you must re-install Microsoft
ActiveSync before establishing IrDA
communication between systems.