NEC PAGEPRO 1100 - Manual (Page 119)

4-43
Cha
p
ter
4
P
rin
te
r D
riv
er
DOS Printing Utilities
To Load the Status Monitor from the DOS Prompt
Type the following at the DOS prompt to display the Status Monitor
screen:
1
Change to the directory you created under “Installing DOS
Printing Utilities” on page 4-41.
Type: cd c:\mltdos
↵
• If you used the directory name we showed in our installation
example, type in the command exactly as shown above. If
you used a different directory name, change mltdos to the
name you used.
2
Type the following command at the DOS prompt.
Type: rep
↵
To Remove the Status Monitor from Memory
■ Type the following at the DOS prompt:
Rep /d
↵
Note
◆ You should use the above step to remove the Status Monitor from
memory if the Status Monitor is interfering with one of your other
software applications or if you need to free up the memory used by
the Status Monitor.