NEC PAGEPRO 1100 - Manual (Page 135)

4-59
Cha
p
ter
4
P
rin
te
r D
riv
er
DOS Printing Utilities
Status Display Screen
The following describes each of the buttons and the commands on the
Status Display Setup menu.
Set Display Mode Command (Setup Menu)
In the dialog that appears when you execute this command, click the
checkbox next to the
Enable Popup setting to toggle popup error mes-
sages on (checked) and off (unchecked). When this feature is turned
on, a dialog box will appear to alert you whenever an error condition
occurs.
• When a popup error message occurs, correct the problem and then
click OK .
• You can control which error conditions cause popup error messages
to appear by using the procedure under “Change Popup Message
Command” below.
Change Hot Key Command (Setup Menu)
The dialog that appears when you execute this command shows the
current hot key combination that launches the Status Display. While
the dialog is open, you can change the hot key combination by pressing
the key you want to change.