NEC PAGEPRO 1100 - Manual (Page 147)

5-9
Ch
apte
r
5
Pr
in
ter
S
tatus
M
oni
tor
an
d Co
ntr
o
l Pa
nel
Using the Control Panel
Printer Setting
Power Save
Power Save lets you set up the printer so it enters a low-power idle
state after a specific time of inactivity.
Click On to turn on Power Save . In the Interval box, type the amount
of time the printer should wait until going into the idle state. You can
also use the arrow buttons to change the
Interval box value.
Click Off to turn off Power Save .
Auto Continue
Turning on Auto Continue causes printing to restart automatically
when a specified amount of time passes after any one of the following
errors occurs:
paper size error, job too complex, memory overflow.
Click On to turn on Auto Continue . In the Time Out box, select the
amount of time the printer should wait until starting the recovery rou-
tine.
Click Off to turn off Auto Continue . When Auto Continue is turned
off, the printer must be reset to resume printing following a printer
overrun or memory overflow error.