N-Tron 9000 - Manual (Page 113)

(Revised 2011-07-20) page 113 of 145
Show Link Utilization
Command Name port show linkutilization
Description Shows the utilization statistics for all the ports including %bandwidth, %in,
%out, RX bytes, and TX bytes for each port.
Syntax port show linkutilization
Parameters None
Examples N-TRON/Admin#[1]> port show linkutilization
NOTES %Bandwidth is the %in or %out value that is higher, not the average value.
Get Flow Control
Command Name port get flowcontrol
Description Displays the current flow control settings on a given port.
Syntax port get flowcontrol <port-no>
Parameters port-no
port number (1 ~ 24)
Examples
N-TRON/Admin#[1]> port get flowcontrol 6
NOTES Check whether port-no is in the valid range. (1 ~ 24)
Get Name
Command Name port get name
Description Displays the name of a given port.
Syntax port get name <port-no>
Parameters port-no
port number (1 ~ 26)
Examples
N-TRON/Admin#[1]> port get name 6
NOTES Check whether port-no is in the valid range. (1 ~ 26)
Get State Of Priority
Command Name port get stateofpriority
Description Displays the priority state of a given port number.
Syntax port get stateofpriority <port-no>
Parameters port-no
port number (1 ~ 26)
Examples
N-TRON/Admin#[1]> port get stateofpriority 6
Priority State of Port[6] is : [disabled]
NOTES Check whether port-no is in the valid range. (1 ~ 26)
Get Intruder State
Command Name port get intruderstate
Description Displays whether the intruder log is enabled or disabled.
Syntax port get intruderstate
Parameters None
Examples N-TRON/Admin#[1]> port get intruderstate
Intruder Log : Disabled
NOTES
Get Priority Level
Command Name port get prioritylevel
Description Displays the priority level on a given port.
Syntax port get prioritylevel <port-no>
Parameters port-no
port number (1 ~ 26)
Examples
N-TRON/Admin#[1]> port get prioritylevel 6
Priority Level of Port[6] is : [1]
NOTES Check whether port-no is in the valid range. (1 ~ 26)