N-Tron 9000 - Manual (Page 15)

(Revised 2011-07-20) page 15 of 145
APPLYING POWER (Side View)

Unscrew & Remove the DC Voltage Input Plug
from the Power Input Header

Install the DC Power Cables into the Plug
(observing polarity).

Plug the Voltage Input Plug back into the Power
Input Header.

Tightening torque for the terminal block power
plug is 0.5 Nm/0.368 Pound Foot.

Verify the Power LED stays ON (GREEN).
Note: Only 1 power supply must be connected to power for minimal operation. For redundant power
operation, V
1
and V
2
inputs must be connected to separate DC Voltage sources. This device will draw
current from both sources simultaneously. Use 16-28 gauge wire when connecting to the power supply.
Recommended 24V DC Power Supplies, similar to: N-Tron‟s P/N NTPS-24-5
 Input AC 100V…240V
 Output DC 24V…28V

Output Current 5A

Peak Current 7.5A for 4 sec.

Power 120W

Peak Power 180W (max 4 sec.)

35 mm DIN-Rail Mountable
 Dimensions: 1.57”W x 4.88”H x 4.61”D