N-Tron 9000 - Manual (Page 77)

(Revised 2011-07-20) page 77 of 145
Configuration – Save or Reset
The Configuration section of the web management gives an administrator the ability to save a
running configuration into the NVRAM. This step is needed in order for the switch to remember any
changes after a power cycle.
The Reset Configuration button will reload N-Tron‟s factory default configuration settings. Doing so will
re-configure the 9000 Series switch to factory defaults.
In many cases it is desirable to restore factory defaults but retain the IP, Slot Configuration, Subnet Mask,
and Gateway Address settings. A choice is provided to this end.