N-Tron 9000 User Manual
Page 23
(Revised 2011-07-20) page 23 of 145
TROUBLESHOOTING
1.
Make sure the (Power LED) is ON.
2.
Make sure you are supplying sufficient current for the version chosen. Note: The Inrush
current will exceed the steady state current by ~ 2X.
3.
Verify that Link LED‟s are ON for connected ports.
4.
Verify cabling used between stations.
5.
Verify that cabling is Category 5E or greater for 100Mbit Operation.
SUPPORT
Contact N-Tron Corp. at:
TEL: 251-342-2164
FAX: 251-342-6353
www.n-tron.com
FCC STATEMENT
This product complies with Part 15 of the FCC-A Rules.
Operation is subject to the following conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause
undesired operation.