Nortel Networks 5500 series User Manual
Page 88
88
Configuring the domain
You can change the VLAN mappings when you add or modify
the network access devices (see
). You specify the Red VLAN when
you add the network access devices to the domain.
The components created by the wizard depend on the selections
you made in the preceding steps. For example, the sample
output illustrates the following options:
•
an existing certificate (Certificate 1) is being used
•
no network access devices is being added
•
the test user is being created
--End--
Creating Domain 1
Creating Certificate 1
Creating Client Filter 1
Name:
nha_passed
Creating Client Filter 2
Name:
nha_failed
Creating Client Filter 3
Name:
nha_system_passed
Creating Client Filter 4
Name:
nha_system_failed
Creating Linkset 1
Name:
nha_passed
This Linkset just prints the Health Agent result
Creating Linkset 2
Name:
nha_failed
This Linkset just prints the Health Agent result
Creating Linkset 3
Name:
nha_system_passed
This Linkset just prints the Health Agent result
Creating Linkset 4
Name:
nha_system_failed
This Linkset just prints the Health Agent result
Creating Group 1
Name:
nhauser
Creating Extended Profile 1
Giving full access when health check passed
Creating "green" vlan with id 110
Creating Access rule 1
Giving remediation access when health check failed
Creating Extended Profile 2
Not using SRS rule for user compliancy:
Creating Authentication 1
Adding user ’nha’ with password ’nha’
Creating Group 2
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100
03.01
Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.