N-Tron 708M12 - Manual (Page 129)

(Revised 2011-07-20) Page 129 of 156
Show or Set CIP Configuration
Command Name Cip
Description Show or set CIP configuration. If no parameters are specified, this command will show
the CIP configuration (same as -show parameter).
Syntax -Cip [-e[nable] | -d[isable] | -show]
Parameters -Cip -show
Show CIP configuration.
-Cip [-e[nable] | -d[isable]]
Set the CIP status to e(nabled) or d(isabled).
Examples
N-TRON/Admin> cip -show
CIP Configuration:
------------------
Status: Enabled
EthIp Interval: 10 ms
Cache Interval: 2000 ms
Identity Information:
---------------------
Product Name: N-TRON 708M12
Vendor: 1006 (N-TRON)
Device Type: 0x0C (Communications Adapter)
Major Revision: 1
Minor Revision: 2
Serial Number: 0xAFFBE400
Connection Information:
-----------------------
Multicast Connections: 0
Unicast Connections: 0
N-TRON/Admin> cip -disable
Changing CIP configuration...
CIP Configuration:
------------------
Status: Disabled
EthIp Interval: 10 ms
Cache Interval: 2000 ms
Identity Information:
---------------------
Product Name: N-TRON 708M12
Vendor: 1006 (N-TRON)
Device Type: 0x0C (Communications Adapter)
Major Revision: 1
Minor Revision: 2
Serial Number: 0xAFFBE400
Connection Information:
-----------------------
Multicast Connections: 0
Unicast Connections: 0
Changes have been made that have not been saved.
N-TRON/Admin>
NOTES