Show or set port configuration, Reset the switch, Cli commands, continued – N-Tron 708M12 User Manual

Page 134

Advertising
background image

(Revised 2011-07-20)

Page 134 of 156

CLI Commands, Continued…

Show or Set Port Configuration

Command
Name

Port

Description

Show or set Port configuration.

Syntax

Port

[-show] [-admin state] [-sd auto | 10h | 10f | 100h | 100f | 1000f] [-flow state][-fhp state][-dp prio] [-dscp state]

[-8021p state] [-pvid vid] [-ual percent][-uah percent] [-security state] portno

Parameters

portno

Port number to configure or show. Specify ―all‖ to show all ports.

-show

Show configuration.

-admin state

Set the admin status for the port to e(nabled) or d(isabled).

-sd

Set the speed and duplex mode for the port. auto = enable auto-negotiation

-flow state

Set the flow control for the port to e(nabled) or d(isabled).

-fhp state

Set force high priority for the port to e(nabled) or d(isabled).

-dp prio

Set the default QOS priority for the port. The range is 0-7.

-dscp
Include DSCP Priority for the port.
-8021p
Include 802.1p Priority for the port.
-pvid vid
Set the VLAN ID for the port. The range is 1-4094.
-ual percent
Set the usage alarm low percentage. The range is 0-100.
-uah percent
Set the usage alarm high percentage. The range is 0-100.
-security
Set the security status for all supported ports.

Examples

N-TRON/Admin> port -sd 100f -flow enabled -dp 7 -pvid 2 5

Usage Usage
Port Port Admin Link Auto Port Dupl Flow Force Include Include Def Port Alarm Alarm Security
No Name Status Stat Nego Spd Mode Control High Pri DSCP 802.1p Pri State PVID Low % High % Status
---- ---- -------- ---- -------- ---- ---- -------- -------- -------- -------- --- ---------- ---- ----- ------ --------
5 TX5 Enabled Up Disabled 100 Full Enabled Disabled Enabled Enabled 7 Forwarding 2 0 100 Disabled


Changes have been made that have not been saved.

N-TRON/Admin>

NOTES

Reset the Switch

Command Name

Reset

Description

Reset (reboot) the switch

Syntax

Reset

Parameters

None

Example

N-TRON/Admin> reset
Preparing for reset.
Cleaning up...
Browser will be redirected to 192.168.2.214.
Disabling SNMP...
Disabling DHCP...
Disabling CIP...
Locking out other processes...
Disable preemption...
Resetting device...

Notes

Advertising