Ports – configuration – N-Tron 708M12 User Manual

Page 46

Advertising
background image

(Revised 2011-07-20)

Page 46 of 156

Ports – Configuration

The Configuration tab under the Ports category will show a detailed overview of all the active ports on the
switch. The overview will display the following information:

Port Number

This is the port index.

Port Name

This field displays the name of the port. The designation of TX is for copper ports, and FX is for fiber optic ports.

Admin Status

This configurable field displays the existing status of the port whether it is Enabled/Disabled.

Link Status

Current Link state of the port.

Auto Negotiation State

This configurable field displays the current auto-negotiation state whether it is Enabled/Disable.

Port Speed

This configurable field displays the speed of each port 10/100/1000 Mbps.

Duplex Mode

This configurable field displays the existing mode of the port whether it is Full Duplex/Half

Duplex.

Flow Control State

This configurable field displays the existing flow control status of each port. When enabled, the

individual port supports

half-duplex back pressure and full-duplex flow control. The default is

Disabled.

Port State

The current RSTP status of a port. It may contain Disable/Discarding/Learning/Forwarding.

PVID

This configurable field displays the existing port VLAN ID setting. The allowable range is 1-4094.

Usage Alarm Low (%)

The bandwidth utilization percentage below which a fault will be triggered if enabled. For half duplex the bandwidth

utilization percentage is the sum of both RX and TX bandwidth utilization, and for full duplex this is the higher of TX or

RX bandwidth utilization. See Port Utilization View and Port Usage Fault on Fault Configuration View.

Usage Alarm High (%)

The bandwidth utilization percentage above which a fault will be triggered if enabled. For half duplex the bandwidth

utilization percentage is the sum of both RX and TX bandwidth utilization, and for full duplex this is the higher of TX or

RX bandwidth utilization. See Port Utilization View and Port Usage Fault on Fault Configuration View.

Advertising