Eizo RADIFORCE RX211 - Manual (Page 16)

1
2. Cable Connection and Screen Adjustment
-. Connecting the signal cable
NOTE
•Be sure that the power switches of both the PC and the monitor are OFF.
•Refer to the PC user's manual when connecting the monitor.
1
Rotate the monitor ninety degrees counter-clockwise into the portrait
position.
2
Plug the signal cable into the connector at the rear of the monitor and
the other end of the cable into the video connector on the PC.
After connecting, secure the cable connectors with the attached screw-in fasteners.
Digital Input
Connect to SIGNAL1 (DVI-D Connector).
Signal Cable Connector on PC PC
Signal cable (FD-C39 enclosed) Video Output
Connector / DVI-D
• Exclusive graphics board
(p. 42)
Analog Input
Connect to SIGNAL2 (D-Sub 15 pin Connector).
Signal Cable Connector on PC PC
Signal cable (MD-C87 enclosed) Video Output Connector /
D-Sub mini 15 pin
• Standard graphics card
• Power Macintosh G3
(Blue & White) / Power
Mac G4 (VGA)
SIGNAL1
DVI-D
Power cord
SIGNAL2 D-Sub mini 15