NEC IP3AT-8WV(AUSTRALIA) - Manual (Page 26)

10
• HOW TO CHARGE THE
BATTERY
Be sure to charge the battery before using the
phone for the first time. Use one of the
following:
● Cradle
● AC Adapter (direct connection)
By using the Cradle:
The phone can be charged by using the cradle.
You can also charge the battery by inserting the
battery pack alone in the slot on the cradle. This
is useful when you have a spare battery.
(1) Insert the AC adapter plug (mini USB) into
the USB connector in the back of the cradle.
(2) Plug in the AC adapter into an appropriate
AC outlet.
(3) Place the phone and/or the spare battery
pack as shown below. When placing a
battery pack into the slot, insert it so that the
label faces downward.
Note: Face the label of the battery pack
downward when inserting the battery
pack.
(4) The LED on the cradle lights red, indicating
the battery is being charged. When the
phone battery is not being charged the Info
LED turns off.
(5) The LED on the cradle lights green when the
spare battery is fully charged. After this,
charging to the phone battery will start and
the Info LED lights red.
(6) The Info LED lights green when the phone
battery is fully charged.
An empty battery pack can be fully
charged in about 4 hours.
If any abnormality is found in the
battery, the LED on the cradle
lights off. In this case, please
contact your network
administrator.
In the case you place the phone on
the cradle and insert the spare
battery in the slot at the same time,
the spare battery will be charged
first.
Please insert the spare battery in
the slot on the cradle or remove it
as following figure.
AC outlet
AC Adapter
AC adapter plug
Spare Battery (optional)
Info LED
Indicate charge status
Cradle (Battery Charger)
LED
Indicate charge status
TIP
TIP
TIP
USB connector
TIP