NEC IP3AT-8WV(AUSTRALIA) - Manual (Page 9)

FCC Portion
---------------------------------------------------------------------------
This equipment has been tested and found to comply within the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
● Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
Caution:
Any changes or modifications not expressly approved by the party responsible for product compliance
could void the user's authority to operate the equipment.
To comply with FCC RF exposure compliance requirements, this device must not be co-located or
operating in conjunction with any other antenna or transmitter.
Important Note:
This equipment complies with FCC radiation exposure limits.
FCC Rule Parts Frequency Range(MHz) Output Watts
15C 2412.0-2462.0 0.100
Power Output is Conducted. Body-worn operations are restricted to belt clips, holsters or similar
accessories that have no metallic component in the assembly. End users must be informed of the body
worn requirements for satisfying RF Exposure compliance. The highest reported SAR values are:
Body-worn 0.15W/kg.