Nike + SPORTBAND - Manual (Page 13)

13
The Nike+ SportBand User’s Guide
If you’ve successfully completed a calibration run or walk, the date and distance of the
run or walk will appear.
If you didn’t run or walk the correct distance, or if you mixed running with walking, the
message that “no walks or runs were useful” will appear. Repeat the process until a
calibration run or walk is successful.
If the Calibration tab shows a useful calibration run or walk, you can adjust the distance
and improve accuracy. For example, if you know you ran exactly a mile, but the Calibra-
tion tab setting shows that you ran just over or just under a mile, you can make adjust-
ments manually using the up and down buttons. (fig.17)
Your Nike+ SportBand can store calibration information for up to 8 sensors. Each time
you get a new sensor, you will have to calibrate it.
Important: Before you calibrate a second time, you must first reset your run or walk in
the Calibration tab settings. Click the Reset button to return back to the original factory
calibration settings. This will improve the accuracy of subsequent calibrations.
Note: Even after calibrating, the accuracy of the distance measurements may vary de-
pending on gait, running surface, incline, or temperature.
Note: Calibrating for your target “race pace” will give you even better accuracy on race day.
To customize more settings, select another tab. When you are finished, click the Done
button. This will save your changes, close the settings window, and take you back to the
Nike+ Utility main window.
fig.17
User Time Calibration
Adjust the value of your 16 SEPT 2008 walk , if needed.
Adjust the value of your 17 SEPT 2008 run, if needed.
* The distance must be greater than 0.25 MI (or 0.4 KM).
Learn about calibration. Done
1.9 km RUN 1.2 mi
0. 8 km WALK 0.5 mi