NEC MobilePro 790 - Manual (Page 54)

3-6 Introducing Windows CE
4. Select the appropriate port setting, COM1 @ 57600, COM1 @ 9600,
IrDA, LPT1, or Network.
5. Select other printing attributes as required.
6. Tap OK.
Note
With the optional printer cable (MC-RC3E) connected to the serial
port of your NEC MobilePro, you can print to a supported, high-speed
parallel printer.
For information about MobilePro accessories, access the web site
http://www.neccomp.com.
1
1 For U.S. and Canada only. If you purchased this computer outside the U.S. and Canada,
contact a local NEC dealer in your country.
For additional details about using the IR port for printing and transferring
data, refer to the section in Chapter 4, “Using the IR Port.”
Network Capabilities
Your MobilePro takes full advantage of the networking capability offered
through Windows CE and the PC card port. The operating system
supports Ethernet LAN and serial line interface protocol (SLIP) used with
Cellular Digital Packet data (CDPD) so you can have cable- or wireless-
based network communications using an Ethernet LAN PC card. In
addition, you can use CompactFlash type II Ethernet cards on your NEC
MobilePro.
Creating a Network (Ethernet) Connection
To create a network (Ethernet) connection, you must install and configure
an Ethernet card. The drivers for the card may already exist on your
device. NEC also has included drivers for the Proxim RangeLAN2.
1. Insert the Ethernet card into your device and connect it to your
network cable. You must have an NE2000-compatible Ethernet card,
one of the wireless Ethernet cards described above, or have installed
drivers supplied with the card.
You may see a message warning about battery power. If you have an
A/C adapter, plug it into your device.