NEC DAC Battery N8103-102 - Manual (Page 52)

30
1-5. Installing BBU in Server
Install the BBU in the disk array controller and the server in the following procedure:
1. Remove the additional slot cover and screw from an unused PCI slot. Remove
the cables from the disk array controller.
2. Remove the disk array controller from the server, and connect the battery cable to
the battery connector on the disk array controller.
NOTE: The BBU has two battery cable connectors. Either of two
connectors may be used. Select either connector appropriate to your
system environment (e.g., location to install in the server and cable
routing condition) to connect the battery cable.