NEC DAC Battery N8103-102 - Manual (Page 9)

vii
Power Supply and Power Cord Use
CAUTION
ON
Disconnect the power cord(s) before installing or removing the product
in/from the server.
AC AC
Make sure to power off the server and disconnect the power cord(s) from a power
outlet before installing/removing the product in/from the server, or connecting with
the peripheral devices. All voltage is removed only when the power cords are
unplugged.
Do not use any damaged cable.
Make sure the cable condition before connection. Using the damaged connector,
bent connector pin, or dirty connector may cause a fire due to short-circuit.
Do not hold the power plug with a wet hand.
Do not disconnect/connect the plug while your hands are wet. Failure to follow this
warning may cause an electric shock.
Do not pull the cable when disconnecting the power cord.
When disconnecting the power cord from the server, hold the plug and pull it straight
out. Pulling the cord out by the cable portion could damage the cable to result in an
electrical shock hazard or a fire.