Novatel GNSS Receiver and Antenna SMART-AG - Manual (Page 56)

56 SMART-AG User Manual Rev 5
Chapter 5 Bluetooth® Configuration
4. Open a terminal program (HyperTerminal, for example) and configure it to the serial port speci-
fied in the Bluetooth configuration utility. In the above example, the terminal program must be
configured to connect through COM21.
5. Configure the port settings as follows:
9600 bps, no parity, 8 data bits, 1 stop bit, no handshaking, echo off
6. Through the terminal program, connect to the Bluetooth serial port and verify the connection.
7. Type the following VERSION log request into the command prompt to ensure that the connection
works:
LOG VERSION
The Bluetooth icon in the task bar turns green when it is connected, see Figure 26 below.
Figure 26: Bluetooth Connected: Green
5.5 Stop Communicating with the SMART-AG Using Bluetooth
wireless technology
1. Double-click on the Bluetooth icon in the task bar, see Figure 21 on page 53, or select Programs |
My Bluetooth Places from the Start menu in Windows. The My Bluetooth Places window opens.
2. Click on the Search for devices in range option from the Bluetooth Tasks side bar on the left of
the My Bluetooth Places window. Devices with Bluetooth wireless technology enabled within
range appear in the Entire Bluetooth Neighborhood folder, see Figure 23 on page 54.
3. Double-click on the SMART-AG device icon in the Entire Bluetooth Neighborhood window, see
Figure 23 on page 54. The computer searches for available services. If Bluetooth wireless tech-
nology is working properly, COM port service appears.
4. Right-click on the COM21 icon and select the Disconnect Serial COM Port option. A COM21
dialog box appears, see Figure 27, to confirm that you want to disconnect.