Eizo CG243W - Manual (Page 34)

 Chapter 6 Reference
Chapter 6 Reference
6-1. Attaching an Arm
The stand can be removed and replaced with an arm (or another stand) to be attached to the monitor. Use
an arm or stand of EIZO option.
Attention
When attaching an arm or stand, follow the instructions of their user’s manual.
When using another manufacturer’s arm or stand, confirm the following in advance and select one conforming to
the VESA standard.
- Clearance between the screw holes: 100 mm × 100 mm
- Thickness of plate: 2.6 mm
- Strong enough to support weight of the monitor unit (except the stand) and attachments such as cables.
Use the screws as described below.
- CG223W: The screws fixing the stand to the monitor
- CG243W: The screws supplied with this monitor (M4 × 12mm)
When using an arm or stand, attach it to meet the following tilt angles of the monitor.
- Up 45 degrees, down 45 degrees (horizontal display, and vertical display rotated 90 degrees clockwise)
Connect the cables after attaching an arm.
Do not adjust the height of the stand removed from the monitor. When adjusted without attached monitor, it
causes the personnel injury or the damaged to the stand.
Since the monitor and arm are so heavy, dropping them may result in injury or equipment damage.
•
•
•
•
•
•
[Attachment Procedure]
1
Lay the LCD monitor on a soft cloth spread over on a stable surface with the
panel surface facing down.
2
Remove the stand.
Prepare a screwdriver. Unscrew the four screws securing the unit and the stand with the screwdriver.
3
Attach the monitor to the arm or stand.
Secure the monitor to the arm or stand using the screws specified in the user’s manual of the arm or stand.